1. The photo above shows the carriage set up
for a pair.To convert the carriage from pair to single
follow the steps below.Remove
the three bolts that hold the Splinter Bar onto the carriage.
2.
One bolt is located right over the Pole - Spring Assembly.
3. The other two bolts are at each end of the
Splinter Bar (next to the rubber step bumper).Once
these bolts are removed you can lift out the entire Splinter Bar
Assembly.4.
Then slide the Single Horse Single Tree into the attachment point
for the center of the Pair Splinter Bar.Replace bolt and tighten enough to hold in place but not
too much to prevent Single Tree from moving from side to side.Check bolt periodically to ensure that it is still
tightened properly.